Summarry addednum:
I did not include the original question with my first summary, I have
been corrected, and here you go:
I would like to upgrade the ram in my IPX (currently 16mg) I tried
using two 16mg simms, which passed test-memory, but I received Data
Access Exeception on boot. Does any know the correct type /
configuration of memory to use in an IPX.
As always,
This list comes through with shining colors. Within a couple of hours
I received the following responses = all more than acceptable. If all
mailing list were this good, I'd never have to read another a tech
manual :-)
Mark Sherman
Mark@dbs-mia.com
The Reponse Were: (In no Specific Order)
gmp@adc.com [SMTP:gmp@adc.com]
Tim Carlson [SMTP:tim@santafe.edu]
http://www.kingston.com/catalog/wsmemory/sun022.htm
tells you all you need to know
Dave Staggs [SMTP:dstaggs@kcii.com]
use 4 mb simm 501-1812-01
use 16mb simm 501-1822-01 or 501-1915-01
if you have a specific configuration, let me know, i can tell you
where to put them.
for a 32 mb config, put chips in slot 0 u0310 and slot 2 u0308.
Mike Frisch [SMTP:mfrisch@saturn.tlug.org]
You need to use 16MB, 72-pin, TRUE parity RAM (36-bit) and it should
be fine.