2. configuration comes out as:
Configurable Parameters: Current Settings
----------------------- ----------------
1) Lp destination (queue) name [HP750C] change to
2) Model script: [net_dsnj.sol] <------
3) Status log [(No log)] |
4) Default printing language [AUTO] |
5) Queue class [(not assigned)] |
6) Job recovery [ON] |
7) True End-of-Job -----> [(N/A)] |
8) Job monitor | [ON] |
9) Default queue | [NO] |
10) Banner page | [(N/A)] |
| |
| Default Value net_dsnj
Don't set to ON, some time it cause
infinit loop print. I waster whole roll
just for one print out.
Original posting:
>>I tried to configured HP750C plotter (with JetDirect card) use HP
>>Jetadmin software and have following error message:
>>
>>
>> cp: cannot access /etc/lp/interfaces/hp750c
>> ..can't open /etc/lp/interfaces/model.orig/hp750c
>> UX:accept: ERROR: Destination "hp750c" is unknown to the
>> LP print service.
>> ..UX:enable: ERROR: Destination "hp750c" is unknown to the
>> LP print service.
>> ..
>> Finished adding "hp750c" to the spooler.
>>
>>
>>
>>The UNIX system is Ultra Sparc 1 with Solaris 2.5.1 and Jetadmin version
>>0210. Thank you for help.
>>
>>PS: Network between SUN Sparc and Jetdirect work fine.